Dive Centre
You have no items in your cart.

Computers, Watches and Accessories


Suunto "D" Series Battery change

MANUFACTURER: Dive Centre Ltd
CODE: BA001
PRICE:$130.00

During every Suunto Dive Watch battery change these steps are always performed...

1. Remove old O'Ring
2. Clean O'Ring sealing surface in back door
3. Clean O'Ring sealing surface on inside of watch
4. Check Battery Low
5. Power Draw Test
6. Replace Piezo Sticker - As Required
7. Re-Bend negative battery terminals - As Required
8. Test new battery level
9. Replace battery
10. Fit new Seal/O'Ring
11. Replace back door screws - As Required
12. Check buttons
13. Update firmware - As Required
14. Set Time & Date
15. Calibrate Digital Compass
16. Witschi Dry Leak test 30m
17. Wet Dive Test 30m+
18. Recalibration of pressure sensor if required
19. Check & Fit Strap and ready for pickup or delivery

All of this is performed in an ESD (Electrostatic Discharge) Protected work area by our Suunto Certified Technicians.

All Suunto watches must only be opened by our Suunto approved staff. No other store is approved to do this work, has the training or equipment to safely service your Suunto equipment.

Your Warranty is voided, damage or dangerous pressure sensor accuracy issues can occur if staff at any other store opens your watch.

Failure to do this can also cause Electrostatic damage or miscalibration of the pressure sensor (Which can endanger your life with incorrect depth and decompression calculations) and/or leaking that is not covered by warranty!

PLEASE DO NOT take your Suunto Dive Computer to a normal Jeweler - take it to your local dive store and make sure they use our services, or send it to us directly.

All details, prices and availability are subject to change - All rights reserved Dive Centre Ltd 1972-2024